How to make an epoxy SU-8 mold?
At a glance
Making an epoxy SU-8 mold for PDMS soft lithography involves wafer preparation, spin coating of the negative SU-8 photoresist, baking, UV exposure, development and checking measures. Heating and cooling during the soft bake and post exposure bake must be gradual to limit mechanical stress in the photoresist. A spin coater and a hot plate are used to coat and bake the photoresist on a silicon wafer.
- Wafer dehydration
- 15 min at 120°C recommended, for example in an oven
- Spin coating steps
- Low speed for 10 to 30 seconds, then high speed for 30 to 60 seconds
- Bake plateaus
- 65°C then 95°C for soft bake and post exposure bake; plateau time depends on layer thickness
- Exposure wavelength
- 365 nm
To perform 







